When it comes to marble installation, the results are stunning. The material is a timeless beauty that adds resale value to a home. Though porcelain can be very attractive and have an appealing pattern, marble floors are cold and hard to the touch. While porcelain is cheaper than marble, it has its limitations. After installation, the marble floor must be sealed to protect it from stains and scratching. Here are a few tips to help you get the perfect marble floor for your home.
The first step in marble installation is the base. The base should be a flat, waterproof surface. In order to achieve this, you must first remove any existing floor covering. Then, you need to remove the subfloor, which is usually plywood or MDF. After the subfloor is removed, you will need to lay a layer of cement board on top. The cement board adds stiffness and moisture resistance to the flooring. The cement board also bonds well with thin-set mortar adhesive.
Before the marble installation process begins, it is important to prepare the work area. Make sure that it’s completely dry. You can cover the area with Polypropylene board sheets to protect it from foot traffic. In addition, you need to check the site’s conditions and have the main contractor sign off on clearance to lay the tile. When it’s time to lay the tile, all the other work must be completed. Before you can start installing your new marble flooring, make sure you’ve completed all of the other work.
Before you begin your marble installation project, you need to prepare a flat, water-resistant base. You can prepare the floor by removing the existing floor covering and replacing it with the subfloor, which is usually made of MDF or plywood. Next, you need to lay a layer of cement board on top of the subfloor. This cement board provides the required stiffness and moisture resistance. The cement board also bonds well with thin-set mortar adhesive.
Ensure the floor’s flat and smooth base is sturdy and water-resistant. The marble installation process requires a smooth and level foundation. In general, this means removing the existing floor covering and installing a layer of MDF or plywood. After the subfloor has been removed, you’ll need to add a layer of cement board to the base. This will provide extra support and stiffness to the surface. It also helps the tiles to stick better.
It’s important to follow standard HSE guidelines when doing marble installation. The main contractor must make sure that the surface is clean and dry. If the floor is not clean, you should wipe it down with a wet sponge to remove any dirt that may be stuck to the floor. After the subfloor is dry, you can apply the marble tile and grout. The marble tiles should be laid on the sub-floor. If the sub-floor is wood, you’ll need to install plywood underlayment.